Attaching the Regulator:
  1. There is a space in the regulator that can be slipped over the top of the tank.
  2. The regulator has two “pins” that fit in the two holes in the side of the tank at the top. 
  3. When the two “pins” fit into the holes on the tank, the regulator should be tightened on the tank to a snug fit. 
  4. The regulator tightens down on the tank by screwing down the lever sort of like an “old fashioned” nutcracker. 
  5. When the regulator is tightened down tight enough, you should not hear any sound when you open the tank. 

To open the tank (some tanks have a toggle on top of the tank) take the tool provided and fit the tool on the very top of the tank and turn the tank to the open position. (Do not use a regular wrench or pliers. This could cause damage to the tank or even a more serious accident.) You will know that the tank is opened because the gauge on the regulator will move into a different position indicating the quantity of oxygen remaining in the tank.

For example, if the tank is full, then the needle on the regulator gauge will move into the full position. If the tank is only partially full, then the needle on the gauge will move to the position on the gauge to show the contents at that time. (It is a good idea to keep the tool to open the tanks close at hand at all times. Some folks will tie a string around it and tie it to the E-tank cart.)


Safety Issues:
  • Never use any petroleum-based oils or grease on or around the oxygen tanks.
  • Never store the tanks near a flame.
  • Never use or store the tanks in a small-enclosed area.
  • Never allow anyone to operate this equipment that has not been trained to operate the tank and regulator.

Always store tanks in a secured area where they cannot fall or be knocked over.